Pelican ERGO360 User Manual

IP 3113
ERGO360™ SEAT ASSEMBLY INSTRUCTIONS
INSTRUCTIONS D’ASSEMBLAGE POUR SIÈGE ERGO360
MC
INCLUDED COMPONENTS /
COMPOSANTES INCLUSES
Screws / Vis 1/4-20’’
Washers / Rondelles 1/4’’
Nuts / Écrous 1/4-20’’
Caps / Capuchons 1/4’’
8
16
8
8
QTY / QTÉ
REQUIRED TOOLS /
OUTILLAGES NÉCESSAIRES
STEP / ÉTAPE 1
Install the swivel plate to the seat / Installer le pivot au siège
1. Rotate the swivel plate so the two sections
are offset as shown in Figure 1.
Pivoter le pivot du siège an que les sections
tournantes soient décalées de 45 degrés
tel que montré à la Figure 1.
2. Align the holes on the swivel plate with
the holes on the frame under the seat and
insert a screw with washer into each hole
as shown in Figure 2.
Aligner les trous d’une plaque tournante
du pivot du siège avec les trous du tube du
siège et insérer une vis munie d’une rondelle
dans chaque trou du pivot en contact avec
les tubes tel que montré à la Figure 2.
FIGURE 1 FIGURE 2
Wrench / Clés 7/16
NOTICE AVIS
Remove the the base of the seat from the tracks
before starting the seat assembly.
Retirer la base tubulaire des rails avant
de commencer l’assemblage du siège.
2
QTY / QTÉ
Seat / Siège
Swivel plate / Pivot de siège
Base / Base tubulaire
1
1
1
QTY / QTÉ

Pelican ERGO360 Specifications

General

Type	Dry Box
Closure	Latch
Waterproof	Yes
Dustproof	Yes
Crushproof	Yes
O-ring seal	Yes
Pressure equalization valve	Yes
Carrying options	Handle

Summary

Required Tools

Wrench (7/16)

Specifies the 7/16 wrench required for the seat assembly.

Included Components

Screws (1/4-20)

Lists the quantity and type of screws included in the kit.

Washers (1/4")

Lists the quantity and type of washers included in the kit.

Nuts (1/4-20)

Lists the quantity and type of nuts included in the kit.

Caps (1/4")

Lists the quantity and type of caps included in the kit.

Seat Component

Identifies the main seat component included.

Swivel Plate Component

Identifies the swivel plate component included.

Base Component

Identifies the base component included.

Step 1: Install Swivel Plate to Seat

Aligning Swivel Plate and Seat

Rotate swivel plate for offset alignment and attach to seat frame using screws and washers.

Securing Swivel Plate

Secure the assembly with nuts and washers, ensuring a tight and solid fit.

Step 2: Install Base to Swivel Plate

Attaching Base to Swivel Plate

Align base holes with swivel plate, insert screws/washers, and secure with nuts/washers.

Step 3: Install Caps

Securing Screw Tips with Caps

Place protective caps on all exposed screw tips for safety and aesthetics.

Step 4: Put Seat on Tracks

Mounting Seat onto Kayak Tracks

Slide the assembled seat onto the kayak tracks using the designated opening.