PRE-LAUNCH CHECKLIST
•
Remove the tape holding the rudder in an upright position and allow the rudder
to move down to its lower position.
• Check that the drain plug at the bow of the boat is securely in place before
placing the boat in the water.
• Check that the cranks turn freely and are not obstructed by weeds.
• Check that all accessories are properly installed.
• All passengers must wear an approved Personal Flotation Device (PFD). Insist
that children wear a certified Personal Flotation Device that is the right size.
• Always have one buoyant heaving line at least 15m (49’3’’) long and one bailer
or manual bilge pump (or bilge-pumping arrangements).
• Ensure that the boat has navigation lights if it is operated after sunset, before
sunrise or in periods of restricted visibility.
Electric models only:
• The battery is in good working condition.
• The battery is held in place by the strap.
• Make sure the propeller is well secured to the motor.
LAUNCHING PROCEDURE
•
Make sure that all the material used to fasten the pedal boat during
transportation is removed.
• If one person launching, pull with the stern lifted.
• Never drag over rocks or sharp objects as this could damage hull rudder or
rudder post.
• Verify shore conditions before placing unit in water to avoid damaging the hull
with foreign objects.
• Always step into the footwell area in the front of the boat when boarding.
• Always wear a certified Personal Flotation Device.
STEERING
(For models with two steering handles)
• In order to turn to the right, push the handle(s) towards the front of the boat.
• To turn to the left, pull the handle(s) towards the rear of the boat. The boat can be
steered using one handle only.
MOORING / DOCKING
•
Always moor the pedal boat away from rocks and sharp objects.
• Always moor in sufficiently deep water to avoid damaging the hull.
• Never moor the pedal boat against a dock that is not equipped with hull-
protecting bumpers.
• In order to prevent damage to the rudder, do not push pedal boat backwards
when removing it from the water.
CARE AND MAINTENANCE
The best way to clean your pedal boat is to wash it with lukewarm water and
mild soap. Do not use harsh abrasives. Regular cleaning will keep your pedal
boat looking like new. Never attempt to paint the pedal boat because it will not
stick to the hull.
STORAGE
Short term
• Pelican offers a mooring cover to protect your pedal boat from all types of weather
conditions.
• The drain plugs at the bow of the boat should be removed periodically in order
to allow any water accumulation caused by condensation to be evacuated. To
drain: remove the drain plug and stand the pedal boat on its bow.
Long term
• To store your pedal boat for long periods of time, remove the drain plugs and
stand the pedal boat on its bow to remove any water accumulation.
• Set the boat right side up on the ground with a mooring cover.
• Avoid placing heavy objects on the pedal boat. If this should happen and the
plastic is bent due to the pressure, place the boat in the sun and the RAM-X™
will return to its original shape.
• Never store a pedal boat on sawhorses.
• Avoid prolonged or unnecessary exposure to the sun, as this may damage the
boat’s finish.
Electric models only
• Store with the motor in an elevated position.
5
To Next Page
Loading...
