07
OPERATION INSTRUCTIONS
Check Before Turning On The Machine
• Check if the power wire is under good condition.
•
current of the power socket meets the local requirements with safe grounding device,
Put The Machine On The Flat Place
Uneven place may possibly cause the turnover switch at abnormal position, then the
Temperature Control Knob
Insert the plug into the power socket, then turn the Temperature Control knob clockwise,
when hearing the “poop” sound (it means the temperature controller is on), adjust the
Temperature Control knob to the desired tempera-ture level.
Power Switch Knob
Turn the gear knob, so that you can switch among 4 functions of the Fan, Low
600W(1), Middle 900W(2),High 1500W(3).
Turn Off The Heater
• Turn the Power Switch Knob to “0” position.
• Turn the Temperature Control knob anticlockwise to the initial position.
• Remove the power plug, store the heater after the entire machine has become cool.
Safety Protection
• Overheat protection: This heater is equipped with a temperature control component
for overheat protection that will be activated when the internal temperature exceeds
normal operating temperatures. If this occurs, turn the heater off, unplug it, inspect
and remove any objects on or adjacent to the heater. Allow it to cool for a few minutes,
and then plug it back in and resume normal operation.
• Inversion protection: When the whole heater is inverted, the safety system will
automatically cut off the power, and return to the work state before inversion afterthe
body is placed upright.
To Next Page
Loading...
