Ethernet configuration
Ethernet connect will automatically connect to network and when you insert RJ45 connecter.
You can Configure Ethernet connections for static IP, or DHCP etc,
To uncheck option to Turn Off Ethernet automatic connection
The internet connection will use Ethernet when Wi-Fi is Turn On.
WLAN connection
Wi-Fi can only be used when it connects with home Wi-Fi Access Point (AP) or a free unsecured
Wi-Fi hotpot. Under “Wireless & networks”, tap “Wi-Fi” to turn it on. After a moment, your
Wi-Fi network list should populate. If you need to rescan for available networks, tap "scan"
• Turn on WLAN
Tap “Settings” → then “Wireless & networks” → “Wi-Fi”to turn on Wi-Fi. Your
Peloton console lists the networks it finds within range. Tap a network to connect. If
necessary, enter Network SSID, Security, and Wireless password, and tap “Connect”. When
your Peloton console is connected to the network, the wireless indicator appears in the status
bar. Waves indicate connection strength.
BT connection
• Make device discoverable:
You must pair your Peloton console with a device before you can connect to it. Once you pair
your Peloton console with a device, they stay paired unless you unpair them. Under “Settings”,
choose “Bluetooth”. Tap Bluetooth to turn on it and tap “Search for devices”. The Bluetooth
indicator then appears in the status bar.
• Scan for devices
After scanning, there will be a list of the IDs of all available Bluetooth devices in range. If the
device you want to pair with isn’t in the list, ensure that the other device is turned on and set to
be discoverable.
• Pair with the Bluetooth device
To Next Page
Loading...
Need help?
General
