What to do if the beam doesn't move on Pelstar Health o meter 402KL Scales?
If the beam on your Pelstar Scales doesn't move during weighing, the scale might have an improper steel rod connection, or the poise weight may be set higher than the patient's actual weight. Try resetting the weights to a lower setting. Also, make sure the steel rod is properly connected.
How to fix a bar that doesn't move freely on Pelstar Health o meter 402KL?
If the bar on your Pelstar Scales doesn't move freely, it may be sticking or need adjustment. Check if the pointer is touching the side of the trig loop in its range of travel. If it is, realignment of the beam may be necessary. Also, ensure that the upper and lower poise weights are firmly against the shoulder of the beam and adjust the balance ball screw by turning the screw at the left end of the bar.
Safety guidelines for patients and caregivers during weighing.
Detailed instructions for physically assembling the scale components.
Procedure to calibrate the scale to a zero reading before first use.
Steps for accurately weighing a patient and reading the scale.
Example demonstrating how to read and combine measurements from the poise bars.
Instructions on using the height rod to measure patient height.
Examples of reading height measurements in inches, cm, and feet/inches.
A table of symptoms, causes, and corrective actions for scale malfunctions.
To Next Page
General