Pentair Pool Products Nicheless Light AquaLumin II User Manual

AquaLumin
®
II - Nicheless Light Installation Guide
AquaLumin
®
II - Nicheless Light Installation Guide
1
AquaLumin
®
II - Nicheless Light
Installation Guide
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
IMPORTANT NOTICE
This AquaLumin II light will install only with the following AquaLumin II Mounting Brackets,
manufactured after JUNE 6, 1994:
AquaLumin II Vinyl Mounting Bracket Assembly 1" (P/N 78887800)
AquaLumin II Vinyl Mounting Bracket Assembly 3/4" (P/N 78887700)
Section Contents
1. Installing a mounting bracket and light fixture during new vinyl pool construction...........3
2. Replacing light fixture in existing pools......................................................................7
3. Replacing a lamp only..............................................................................................10
Parts List / Replacement Part Kits........................................................................13-15
Minimum Qualifications
• Licensed or Certified Electrician
• Electrician or Qualified Pool Serviceman
• Qualified Pool Serviceman or Homeowner
Housing
Housing
spacer
Mounting
bracket
Mounting
spacer
BACK VIEW
AquaLumin II - Manufactured after June 6, 1994
P/N 99460100 Rev E - 01/14/08
16
P/N 99460100 Rev E - 01/15/08

Pentair Pool Products Nicheless Light AquaLumin II Specifications

General

Brand	Pentair Pool Products
Model	Nicheless Light AquaLumin II
Category	Work Light
Language	English

Summary

General Information, Safety, and Support

Important Safety Instructions

Critical safety guidelines for installation and operation.

Technical Support and Replacement Parts

Contact information and available replacement part kits.

Installing in New Vinyl Pools

Electrical System Preparation and Requirements

Ensure compliance with NEC/local codes, GFCI, bonding, and junction box placement.

Mounting Bracket and Fixture Installation

Steps for hole cutting, hub installation, liner integration, and securing the fixture.

Electrical Connections and Operation Check

Connecting wiring, ensuring submersion, and performing an initial operation check.

Replacing Light Fixture in Existing Pools

Electrical System Verification and Preparation

Verify pool electrical system meets NEC and local codes before replacement.

Fixture Removal and Installation Process

Procedures for removing the old fixture and installing the new one, including wiring.

Replacing the Lamp Only

Safety Precautions for Relamping

Turn off power, allow lamp to cool, and handle new lamp with care.

Lamp Removal and Reassembly Steps

Steps for removing the old lamp, replacing the lens gasket, and reassembling the fixture.