Pentair Goyen Mecair FFD - 6 SETTING UP THE FFD; 6.1 SAFETY INFORMATION; 6.2 CONTROL PANEL OVERVIEW

14 INSTALLATION AND OPERATION MANUAL – OWNER'S RECORD FFD MANUAL – FILTER FAILURE DETECTOR
6.1 SAFETY INFORMATION
WARNING! – HAZARDOUS VOLTAGES
Be aware that during the setup procedure, the FFD may be connected to the mains supply!
6.2 CONTROL PANEL OVERVIEW
Figure 7: FFD control panel overview
'
The FFD can be set up and operated using the controls located on the raised sensor control panel (see Figure 7 above):
• two rotary controls (upper/lower) for calibration,
• a MODE slide switch (bottom left) for calibrating the instrument and for setting the alarm delay period,
• a tricolour STATUS LED (at the top of the control panel) to indicate the current system status/alarms.
When the setup of the FFD is complete, replace and secure the enclosure cover lid with the 4 off screws. This prevents
accidental adjustment and unauthorized tampering.
6 SETTING UP THE FFD