Pentair MagicBowl Water Effect - Niche Installation Details; Niche Mounting and Securing; Finish Grade Alignment

MAGICBOWL Water Effect Installation and User’s Guide
MAGICBOWL WATER EFFECT Installation and User’s Guide
5
WATER LEVEL
NICHE
6.2”
Pedestal,
Pool Deck
or Surface
1” (2.54 cm) PVC
Electrical Conduit
1” (2.54 cm)
Schedule 40 PVC
1.5” Water Line
INSTALLING THE MAGICBOWL
™
WATER EFFECT AND NICHE
(AFTER ELECTRICAL REQUIREMENTS ARE MET)
Figure 1.
1. Install the MagicBowl niche in the customer supplied pedestal or mounting
surface, see Figure 1.
Note: The niche is PVC so use PVC cement to connect the water line and
electrical conduit and drain line to the niche.
2. Set the niche in the mounting surface as per current local building codes.
3. Backfill around the niche to the top of the flange, thereby securing the niche into
place.
4. The niche should be installed so that the “finish grade” taking into account tile or
finish surface, is no higher than the top flange of the niche.
The niche flange must
be flush with the top
finished surface of the
bowl mounng surface