Pentair Prowler 720 - Replacing the Remote Control Battery

8
Prowler
™
720 and 730 Installation and User’s Guide
Replacing the Remote Control Battery
1. Remove the top screw (see Figure 13, Step 1).
2. Pull the top of the cover away from the transmitter and then pull upwards (Step 2).
3. Replace the battery and make sure the polarity is the same as the existing battery (Step 3).
4. Push the cover downwards into the 2 slots (Step 4).
5. Push the top of the cover towards the battery until it snaps into place (Step 5).
6. Put the screw back into place.
Figure 13.