Pentax IQZoom 115 - Film Loading Procedure

FILM LOADING
(Ensure the power is off before insertinj? the film.)
1 Slide the back cover release lever down in the
direction of the arrow to open the back cover as
illustrated.
2 Place the film cartridge in the film chamber by fitting
its flat side on lop of the rewind shaft first and then
slide the lop end into the camera.
3 Pull the film leader out far enough from the cartridge
to reach the take-up spool O- Align the tip of the
film with the film leader end mark 0.
Notes;
• Ensure the film is placed properly between the guide
rails
• If there is dirt on the film detector o , film cannot be
wound properly.
e