Pentax IQZoom 115 - Correcting and Imprinting Dates

Correcting the date
1. Depress the Select button 0 to make a different
category of digits on the LCD panel you want to
change blink.
2. Depress the Adjust button 0 to change digits of the
specified category you chose with the Select button
0 . Digits increase by one each time you depress the
Adjust button 0 . Holding down the button will
advance digits continuously.
• The blinking allows precise fine-tuning of the
internal clock to the beginning of a specified minute.
To do so, depress the Select button 0 to make the
blink, and then depress the Adjust button 0 in sync
with a time signal.
3. After the data has been adjusted, depress the Select
button. The bar mark (-) appears on the LCD panel,
indicating that data imprinting choices are possible.
• If you release the shutter while the blinking data is
being corrected, the data cannot be imprinted.
• Numerical indication
Year = 87-19(1987-2019)
Month = 1-12
Day =1-31
Time = 0-23
Minute = 00-59
OPERATIONAL PRECAUTIONS
The data on the LCD panel is imprinted on each frame
you expose.
• -‘Year-Month-Day’* and “Day-Hour-Minute” can¬
not be imprinted at the same time.
• As you release the shutter, the bar (-) mark on the
display blinks for a few seconds, indicating the data
has been imprinted.
• Move the panorama mode selector lever to the right
or left to switch the imprint mode between panorama
and standard.
• The dating unit automatically switches the imprint
mode between the standard and panorama according
to the format mode selected.
• If there is a white or yellow object in the comer of the
picture where the data is imprinted, the data may be
difficult to read. When composing your photo¬
graphs, try to avoid brightly-colored subjects in that
comer.
39