Youcansettheshutterspeedandaperturevaluemanually.
1 Set the mode dial to M.
2 Use the four-way controller to M
change the shutter speed and
aperture value.
< Increases the shutter speed.
• Reduces the shutter speed.
• Makes the aperture larger.
(Reduces the aperture value.) Aperture Shutter speed
• Makes the aperture smaller.
(Increases the aperture value.)
iiiiiiiiiiiiiiiiiiiiiiii_
iiiiiiiiiiiiiiiiiiiiiiii_
If the combination of shutter speed and aperture value do not give an
appropriate exposure, a warning will be displayed.
Ifthe deviation from the appropriate exposure is between -0.3 EV
[] (Lit) and -2.0 EV, [] will light,and if between +0.3 EV and +2.0 EV [] will
light, and the value will be displayed.
Ifthe picture is underexposed at a setting lower than -2.0 EV,
[] (Blinking) [] blinks, and if overexposed at a setting higher than +2.0 EV,
[] blinks.
[] (Lit) Metering is not possible.
il
To Next Page
Loading...
