Pentogon FitBit Surge Band User Manual

- Removal of original band:
1. With the T-5 Torx driver remove all 4
screws from the backside of the FitBit
Surge that attach the band to the display
unit.
NOTE: The screws must be saved to
attach the band adapter (be careful and
work over the pan with edges to prevent
loss of screws)
Place 4 screws in a safe area for re-use in
later steps.
2. Score the sides of the band (not top or
bottom) with a sharp knife (just cutting
the band) to make it easier to pry off.
Instructions for FitBit® Surge Band
replacement and installation of band adapter
- Preparation and Tools Required:
• T-5 Torx bit Driver
(may be supplied
with product)
•Pan with edge (to keep
screws from getting lost during
disassembly/reassembly)
• Knife (for scoring)
(continued)

Pentogon FitBit Surge Band Specifications

General

Brand	Pentogon
Model	FitBit Surge Band
Category	Heart Rate Monitor
Language	English

Summary

FitBit Surge Band Replacement and Installation

Preparation and Tools Required

Lists necessary tools like a T-5 Torx bit driver, a pan with an edge, and a knife.

Removal of Original Band

Instructions on how to remove the original band by unscrewing and prying.

Band Removal and Cleaning Process

Peeling Away the Band

Details on carefully peeling the band from the display unit using a flat object.

Cleaning Display Assembly

Guidance on cleaning adhesive from the display with a soft cloth and water.

Installation of Band Adapters

Locate and Attach Adapters

Instructions to locate the correct band adapters and start attaching them.

Secure Adapters with Screws

Steps for inserting and tightening screws for both large and small end adapters.

Attach New Fitbit Bands

Final step to attach new Fitbit Blaze Bands to the repaired Fitbit Surge.