not serving the service being accessed. The shared IP address will be used in
connecting to hosts on the WAN (e.g., email notification, remote syslog, etc.) The
device will also listen on the IP address when hosts on the WAN access services
served on this device (e.g., web admin accesses from WAN, DNS server, etc.)
Enter the WAN router's IP address in this field. If there are more hosts in addition
to the router on the WAN segment, click the button next to “WAN Default
Gateway” and check the other host(s) on the WAN segment box and enter the IP
address of the hosts that need to access LAN devices or be accessed by others.
Enter the selected WAN's corresponding DNS server IP addresses.
A
- Advanced feature, please click the button on the top right-hand corner to activate.
To enable VLAN configuration, click the button in the IP Settings section.
To add a new LAN, click the New LAN button. To change LAN settings, click the name of the
LAN to change under the LAN heading.
The following settings are displayed when creating a new LAN or editing an existing LAN.
Enter the Pepwave router’s IP address and subnet mask values to be used on
the LAN.
To Next Page
Loading...
