This setting specifies whether or not Wi-Fi clients can scan the SSID of this
wireless network. Broadcast SSID is enabled by default.
Select Auto to allow the Pepwave router to set the data rate automatically,
or select Fixed and choose a rate from the displayed drop-down menu.
This setting enables the filtering of multicast network traffic to the wireless
SSID.
This setting specifies the transmit rate to be used for sending multicast
network traffic. The selected Protocol and Channel Bonding settings will
affect the rate options and values available here.
To allow the Pepwave router to listen to internet group management protocol
(IGMP) network traffic, select this option.
If you use a distributed DHCP server/relay environment, you can enable this
option to provide additional information on the manner in which clients are
physically connected to the network.
Layer 2 refers to the second layer in the ISO Open System Interconnect
model.
When this option is enabled, clients on the same VLAN, SSID, or subnet are
isolated to that VLAN, SSID, or subnet, which can enhance security. Traffic
is passed to the upper communication layer(s). By default, the setting is
disabled.
Maximum Number of
Clients
Indicate the maximum number of clients that should be able to connect to
each frequency.
A
- Advanced feature. Click the button on the top right-hand corner to activate.
This setting configures the wireless authentication and encryption methods.
Available options :
● Open ( No Encryption)
● Enhanced Open (OWE)
● WPA3 -Personal (AES:CCMP)
● WPA2/WPA3 -Personal (AES:CCMP)
● WPA2 -Personal (AES:CCMP)
● WPA2 – Enterprise
To Next Page
Loading...
Need help?
General
