peplink Pepwave MAX 700 - Page 247

Max number of
Clients
A
This field determines the maximum clients that can be connected to APs under
this profile.
Management VLAN
ID
This field specifies the VLAN ID to tag to management traffic, such as AP to AP
controller communication traffic. The value is 0 by default, meaning that no
VLAN tagging will be applied.
Note: change this value with caution as alterations may result in loss of
connection to the AP controller.
Operating
Schedule
Choose from the schedules that you have defined in System>Schedule . Select
the schedule for the integrated AP to follow from the drop-down menu.
Beacon Rate
A
This drop-down menu provides the option to send beacons in different transmit
bit rates. The bit rates are 1Mbps , 2Mbps , 5.5Mbps , 6Mbps , and 11Mbps .
Beacon Interval
A
This drop-down menu provides the option to set the time between each beacon
send. Available options are 100ms , 250ms , and 500ms .
DTIM
A
This field provides the option to set the frequency for beacon to include delivery
traffic indication message (DTIM). The interval unit is measured in milliseconds.
RTS Threshold
A
This field provides the option to set the minimum packet size for the unit to send
an RTS using the RTS/CTS handshake. Setting 0 disables this feature.
Fragmentation
Threshold
A
Determines the maximum size (in bytes) that each packet fragment will be
broken down into. Set 0 to disable fragmentation.
Distance/Time
Converter
A
Select the distance you want your Wi-Fi to cover in order to adjust the below
parameters. Default values are recommended.
Slot Time
A
This field provides the option to modify the unit wait time before it transmits. The
default value is 9 μs .
ACK Timeout
A
This field provides the option to set the wait time to receive acknowledgement
packet before doing retransmission. The default value is 48 μs .
Frame
Aggregation
A
With this feature enabled, throughput will be increased by sending two or more
data frames in a single transmission.
Frame Length
This field is only available when Frame Aggregation is enabled. It specifies the
frame length for frame aggregation. By default, it is set to 50000 .
A
- Advanced feature. Click the button on the top right-hand corner to activate.
https://www.peplink.com
247
Copyright @ 2021 Peplink