Perfect Power SMT8-T5

Need help?

Do you have a question about the Perfect Power SMT8-T5 and is the answer not in the manual?

Summary

1. INTRODUCTION

2. HOW DOES IT WORK?

SMT8 T_5 Functions

Monitors and modifies engine signals for tuning and data collection.

3. CALIBRATION

3.1 AMP CALIBRATION

Calibrates the AMP sensor by setting LOW and HIGH voltage/pressure points.

3.2 ENGINE TEMPERATURE CALIBRATION

Calibrates the engine temperature sensor by setting LOW and HIGH voltage/temperature points.

3.3 RPM CALIBRATION

Calibrates RPM by setting LOW/HIGH end points or customizing the scale.

3.4 TPS CALIBRATION

Adapts the SMT8T_5 range to the mechanical range of the TPS sensor.

3.5 DISPLAY OPTION

Configures the external display option using the AUXOUT pin for various measurements.

4. TERMINOLOGY

5. KNOW YOUR ENGINE

6. SMT8 T_5 PIN-OUT

7. COMMUNICATION WIRING AND SET-UP

8. POWER WIRING

9. STARTING THE PC

10. PROFILES: PC SCREEN SETUPS

11. DYNO DISPLAY

11.1 INSTALLATION

Explains connecting AUXIN for road speed measurement for dyno use.

11.2 CALIBRATION

Details DYNO feature calibration for distance per pulse.

11.3 SETTING UP

Guides on setting DYNO measures, trigger, and end points.

11.4 PRACTICAL USE OF DYNO FEATURE

Provides examples and hints for using the DYNO feature to measure performance.

11.5 CALCULATING THE HORSEPOWER

Explains calculating horsepower using the DYNO feature and a 1/4 mile run.

11.6 PRACTICAL USE OF THE FUEL MONITOR

Details connecting and using the SMT8T_5's built-in fuel monitor.

12. SMT8 T_5 SIMULATION

13. BASIC WIRING: FUEL MONITOR

14. BASIC WIRING: RPM

15. BASIC WIRING: TPS

16. IGNITION WIRING

17. DISPLAY WIRING

18. SYSTEM SETUP

19. MINIMUM INSTALLATION AND WORK

20. ANALOG: AMP

21. ANALOG: AFR

22. INJECTION

23. BOOST CONTROL

24. IGNITION CONTROL

25. APPLICATIONS: LIMITING AN AMP SIGNAL

26. APPLICATION: MODIFYING AN AMP SIGNAL

27. APPLICATION: MODIFYING THE TPS SIGNAL

28. APPLICATION: PROVIDING FUEL AT BOOST VIA AN EXTRA INJECTOR

29. APPLICATION: MODIFYING LAMBDA

30. APPLICATION: IGNITION MODIFICATION

31. APPLICATION: BOOST CONTROL

32. AUXILIARY OPERATIONS

32.1 FREQUENCY MODIFICATION

Details using AUXIN/AUXOUT for frequency modifications via setup options.

32.2 PWM MODIFICATION

Details using AUXIN/AUXOUT for PWM modifications via setup options.

32.3 BOOST CONTROL

Details using AUXIN/AUXOUT for boost control via setup options.

32.4 DISPLAY OUTPUT

Details using AUXOUT for display output via setup options.

32.5 DYNO DISPLAY

Details using AUXIN/AUXOUT for DYNO display via setup options.

32.6 FUEL MONITOR

Details using AUXIN/AUXOUT for FUEL MONITOR via setup options.

32.7 PULLUP

Details using AUXOUT as a 2K2 pullup resistor via setup options.

32.8 SUMMARY AUXILARY OPERATIONS

Summarizes the use of input/output pins for various auxiliary signal assignments.