TRAMPOLINE
Lead trapeze shockcords before putting tram-
poline on hulls. Tie one piece of 1/8" x 2’
paracord to one end of shock cord using a
small bowline knot.
Feed the line through the white fairlead on
side of hull and out the other side. Continue
across to the other hull and repeat procedure.
The trapezes are continuous from one hull to
the other.
If one of the fairleads should come loose dur-
ing assembly, simply apply some silicone
sealant and push into place.
To install the trampoline, first unzip and
remove the rear section. Slip the front of the
trampoline onto the front crossbar.
5
To Next Page
Loading...