Shackle the jib blocks to each of the two bul-
let blocks on the crosswire.
Adjust the cleat angle as high as possible
using the side set screws. Most people prefer
this position.
The jib blocks have a ratchet which can be
turned off and on by using the button on the
side of the block.
Tie each 1/4" x 8 1/2’ line completely around
the jib block shackle – not through.
Lead the line around the bullet block on the
adjuster plate and through the aluminum
cleat on the opposite side of the boat leading
line through the trampoline sock.
9
To Next Page
Loading...