Battery installation/replacement
MAINTENANCE AND STORAGE
ENVIRONMENT PROTECTION
• Do not dispose of electrically powered products with household wastes.
They should be utilized in proper plants.
• Obtain information on wastes utilization from your seller or local authorities.
• Used up electric and electronic equipment contains substances active
in natural environment.
• Unrecycled equipment constitutes a potential risk for environment and human health.
7
• Make sure the screws are properly tightened to be able to work safely. Use only original
accessories and original spare parts.
• If the device is not used, it should be stored in a dry place, away from children.
• In case of excessive sparking at the motor, have the condition of motor brushes
checked by skilled personnel.
• If the cable is damaged, replace it with another one which has the same
characteristics. Entrust this operation to a qualified technician or a repair shop.
• All defects should be repaired by a service workshop authorized by the manufacturer.
1. Slide cover off bottom of unit and remove battery carrier.
2. Remove batteries from battery carrier (if installed).
3. Install new batteries, negative side of each battery to the spring in each slot.
4. Reinsert battery carrier and replace slide cover.
NOTE: carrier must be inserted properly to operate. It can only be inserted in one
orientation, but be sure the side with exposed contacts is inserted first. A tab on the end
of the carrier should be visible when installed properly.
Check out the collection of automotive tools we offer.
To Previous Page
Loading...
Need help?
General