To Next PageTo Next PageWhat causes the conveyor rollers to run intermittently on my Performax 22-44 Plus?
Intermittent running of the conveyor rollers on your Performax Sander is caused by a loose shaft coupling. Align the shaft flats of the gear motor and drive roller and then tighten the shaft coupling set screws.
What to do if the conveyor belt does not move on my Performax 22-44 Plus?
If the conveyor belt on your Performax Sander does not move, it is because the shaft coupler is not attached. Attach the shaft coupler.
General| Type | Drum Sander |
|---|---|
| Drum Length | 22 inches |
| Maximum Sanding Width | 22 inches |
| Minimum Sanding Thickness | 1/32 inch |
| Motor Power | 1.5 HP |
| Sandpaper/Abrasive Width | 22 inches |
| Maximum Sanding Thickness | 4 in |
| Speed | 1725 RPM |
| Dust Port | 4 in |
Details the terms and conditions of the manufacturer's warranty.
Explains grounding requirements for 115V operation and adapter use.
