Performax 241-0967 User Manual

16
INSTALLING ACCESSORIES – cont`d
5. Press the spindle lock button and engage it
in the spindle. While holding the spindle
lock button down, hand-tighten the collet by
turning it clockwise.
NOTE: Do not use pliers to tighten the collet
nut. Use the small wrench (4) supplied. Over
tightening will cause damage to the tool.
6. Pull on the accessory to ensure it is
securely in place.
SELECTING PROPER SPEEDS
Different speeds are required depending upon
the type of operation being performed. The
following chart outlines those basic speeds:
ASSEMBLY AND OPERATING
Fig. 3
OPERATION
SPEED
Cutting metal
Maximum
Sanding wood
Maximum
Cutting hard metal
Maximum
Engraving metal
Med-Max
De-burring
Med-Max
Drilling holes
Med-Max
Removing rust
Med
Sharpening
Med
Polishing
Slow
For safety reasons, the operator must
read the sections of this Owner’s
Manual entitled "GENERAL SAFETY
WARNINGS", "POWER TOOL
SAFETY", "SPECIFIC SAFETY RULES",
"EXTENSION CORD SAFETY" and
"SYMBOLS" before using this rotary
tool.
Verify the following every time the
rotary tool is used:
1. Safety glasses, safety goggles, or
face shield are being worn.
2. Accessory is in good condition
and not damaged in any way.
3. Workpiece is properly secured.
Failure to observe these safety rules
will significantly increase the risk of
injury.
!
WARNING

Performax 241-0967 Specifications

General

Brand	Performax
Model	241-0967
Category	Power Tool
Language	English