2 of 6
Assembly Instructions:
Getting Started
Unpack all parts and layout on packing material. Visually inspect the corners. These are the most susceptible to
minor variation through the shipping and handling process. If you find a corner bent out of place, use you hand and
gently move the corner back to the designed shape. Also during shipping and handling some of the tabs used for
engaging the panels together may have become closed. Visually inspect all panels and if found that some are
closed, use a small blade screwdriver to push the tabs from behind to open slightly. (it is recommended to push
tabs out slightly for ease of assembly, and then tap back down with a rubber mallet, to tighten engagement). An
example of pushing the tabs out and how the engagement process works is shown below:
Push tab slightly from
back side to open
Small blade screwdriver
Piece with tab
goes under piece
with rectangular
hole
Side part
Side part
Tab fully engaged
Tap tab with rubber
mallet to tighten
engagement
To Next Page
Loading...
Need help?
General
