6 of 6
Step 8 – Final Assembly
Adjust levelers so unit is square and doors open / close freely
Wall Attachment
Insert Screw/Washer (part M & N) thru one of the upper slots in right or left back panel aligning with wall stud. (For
masonry wall, alternative fasteners are required – not included). Mark screw position in wall and drill 1/8” pilot hole.
Secure fastener into wall stud being sure not to engage screw too deeply to avoid bending the cabinet back.
Some of the materials used in the packaging to protect the parts from damage may leave dust or smudges on the
steel panels. It is recommended after assembly is complete to use mild soap and water with soft cloth to wipe
the unit clean.
Questions？：Please call toll free (866) 441-5080
J62310E
To Previous Page
Loading...
Need help?
General
