To Next PageTo Next PageWhat to do if Perkin-Elmer XRpad2 4336 Security Sensors emit smoke?
If your Perkin-Elmer Security Sensors emit smoke, fumes, or strange sounds, immediately turn off the X-ray detector. Then, turn off and unplug the power supply from the AC outlet. Finally, immediately ask your establishment’s safety representative to contact your dealer, distributor, or device manufacturer.
Safety guidelines regarding exposure to ionizing radiation.
Explanation of warning symbols, danger, caution, and note indicators.
Guidance on proper installation and environmental conditions for detector operation.
Information on connecting and handling interface, power unit, and cables.
Safe handling procedures for the X-ray detector and its components.
Safety precautions and guidelines for the rechargeable lithium battery pack.
Safety considerations and regulations related to wireless network connectivity.
Daily checks to perform on cables and detector before and after use.
Monthly checks for the detector, IPU-2, and battery packs.
Annual inspection procedures, including performance tests and checks.
Instructions on when and how to acquire new calibration files for the detector.
Safe procedures for cleaning the X-ray detector and its components.
Guidance on interpreting error messages and resolving common problems.
A general introduction to the XRpad2 4336 as a cassette-sized flat panel detector.
Specifies environmental conditions for transport, storage, and operation of the detector.
Technical specifications of the XRpad2 4336 detector, including sensor, electronics, and performance.
Illustrates the physical dimensions and measurements of the X-ray detector.
Lists approved accessories for the X-ray detector and important usage guidelines.
Describes the setup and connection procedure for the detector in wired mode.
Explains the setup and connection procedure for the detector in wireless mode.
Important checks and precautions to take before powering on the detector.
Step-by-step instructions for powering on the X-ray detector in wired and wireless modes.
Procedure for safely powering down the X-ray detector.
Outlines the general steps for acquiring a clinical image using the detector.
Declaration of electromagnetic emissions and guidance for the detector's use.
Official statement of compliance with EU directives for the XRpad2 4336.
FCC compliance statement regarding interference for US operations.
Industry Canada compliance statement regarding interference and RF exposure.
Industry Canada compliance statement in French regarding interference and RF exposure.
Korean compliance statement regarding radio equipment.
General| Brand | Perkin-Elmer |
|---|---|
| Model | XRpad2 4336 |
| Category | Security Sensors |
| Language | English |
