Perlick H80CIM SERIES User Manual

PERLICK RESIDENTIAL UNDERCOUNTER CUBELET ICE MAKER PRODUCT MANUAL
28 | perlick.com/residential
MAINTENANCE
CLEANING AND SANITIZING INSTRUCTIONS
The appliance must be cleaned and sanized at least twice a
year. More frequent cleaning and sanizing may be required
in some condions.
To prevent injury to individuals and damage
to the appliance, do not use ammonia type cleaners.
Carefully follow any instrucons provided
with the cleaning and sanizing soluons.
Always wear liquid-proof gloves and goggles
to prevent the cleaning and sanizing soluons from coming
into contact with skin or eyes.
DANGER
!
DANGER
!
DANGER
!
Do not use ice made from the cleaning and
sanizing soluons. Aer cleaning and sanizing, be careful
not to leave any soluon in the appliance.
Do not place ngers or any other objects
into the ice discharge opening (extruding head).
DANGER
!
DANGER
!
1. Cleaning Soluon
Dilute 1.6 . oz. (47 ml or 3.2 tbs) of Nu-Calgon “Liquid Ice
Machine Cleaner” with 1 qt (1 l) of warm water. This is a
minimum amount. Make more soluon if necessary.
For safety and maximum eecveness, use
the soluon immediately aer diluon.
2. Cleaning Procedure
1) Move the control switch to the “OFF” posion.
2) Remove all ice from the storage bin.
3) Move the control switch to the “DRAIN” posion.
4) Allow the water system to drain for 1 minute.
5) Move the control switch to the “OFF” posion.
6) Using a clean funnel and hose (not included),
pour 1 qt (1 l) of cleaning soluon over the extruding
head (See Fig. 24.) Allow the appliance to sit for
10 minutes before operaon.
7) Make sure at least 10 minutes have elapsed since you
poured the cleaning soluon over the extruding head,
then move the control switch to the “ICE” posion.
8) Allow the appliance to make ice for 20 minutes, then
move the control switch to the “DRAIN” posion.
9) Allow the water system to drain for 1 minute.
10) Move the control switch to the “ICE” posion.
11) Aer the gear motor starts, move the control switch
to the “DRAIN” posion.
12) Allow the water system to drain for 1 minute.
13) Move the control switch to the “OFF” posion. In
severe water condions, repeat the cleaning
procedure.
Fig. 24
Slope
Scoop Holder
Extruding Head
Funnel and Hose
(not included)
CAUTION

Perlick H80CIM SERIES Specifications

General

Brand	Perlick
Model	H80CIM SERIES
Category	Ice Maker
Language	English