Perlick H80CIMS-AD User Manual

PERLICK RESIDENTIAL UNDERCOUNTER CUBELET ICE MAKER PRODUCT MANUAL
30 | perlick.com/residential
MAINTENANCE
STORAGE BIN DRAIN
In some condions, slime may build up inside the storage bin
drain and prevent water from draining properly. To prevent this
buildup, perform the following procedure once every 3 months
or as oen as necessary for condions.
If the storage bin drain becomes clogged,
water could build up in the bin and overow, leading to costly
water damage.
1) Move the control switch to the “OFF” posion
To reduce the risk of electric shock, do not
touch the control switch with damp hands.
2) Remove all ice from the storage bin.
3) Mix a batch of sanizing soluon by dilung
1.25 .oz. (37 ml or 2.5 tbs) of a 5.25% sodium
hypochlorite soluon (chlorine bleach) with
2.5 gallons (9.5 l) of warm water. Using a chlorine test
strip or other method, conrm that you have a
concentraon of about 200 ppm.
For safety and maximum eecveness, use
the soluon immediately aer diluon.
4) Slowly pour the sanizing soluon into the
storage bin.
5) Aer all of the soluon has drained, clean the storage
bin liner with a neutral cleaner. Rinse thoroughly with
clean water.
6) Move the control switch to the “ICE” posion to start
the automac icemaking process.
CONDENSER
Check the condenser once a year, and clean if required by
following the steps below. More frequent cleaning may be
required depending on locaon.
Condenser ns are sharp. Use care when
cleaning.
1) Move the control switch to the “OFF” posion, then
unplug the appliance from the electrical outlet
To reduce the risk of electric shock, do not
touch the control switch or plug with damp hands.
2) Remove the screws securing the front panel, then
remove it (See Fig. 25).
3) Remove the screws securing the louver, then
remove it.
4) Use a brush aachment on a vacuum cleaner to gently
clean the condenser ns. Do not use too much force,
otherwise the ns could be damaged.
5) Replace the louver and front panel in their correct
posions. Ensure that the screws are securely in place.
6) Plug the appliance back in. Move the control switch to
the “ICE” posion to start the automac ice making
process.
DANGER
!
Front Panel
Louver
Fig. 25
Screws
Screws
Condenser
DANGER
!
DANGER
!
CAUTION
WARNING

Perlick H80CIMS-AD Specifications

General

Brand	Perlick
Model	H80CIMS-AD
Category	Ice Maker
Language	English