Perlick H80CIMS-AD User Manual

PERLICK RESIDENTIAL UNDERCOUNTER CUBELET ICE MAKER PRODUCT MANUAL
perlick customer service (800)558-5592 | 29
MAINTENANCE
CLEANING AND SANITIZING INSTRUCTIONS (cont.)
3. Sanizing Soluon
Dilute 1.25 . oz. (37 ml or 2.5 tbs) of a 5.25% sodium
hypochlorite soluon (chlorine bleach) with 2.5 gallons
(9.5 l) of warm water. This is a minimum amount. Make
more soluon if necessary. Using a chlorine test strip or
other method, conrm that you have a concentraon
of about 200 ppm.
For safety and maximum eecveness, use
the soluon immediately aer diluon.
4. Sanizing Procedure - Inial
1) Using a clean funnel and hose, pour 1 qt (1 l) of
sanizing soluon over the extruding head. Allow the
appliance to sit for 10 minutes before operaon.
2) Remove the slope from the storage bin by carefully
bending it in the center and releasing it from the
2 slope shas.
3) Remove the scoop. Remove the 2 thumbscrews
securing the scoop holder, then remove it.
4) Pour some of the sanizing soluon into a separate,
clean container. Using this sanizing soluon and a
clean cloth, wipe down the slope, scoop, scoop
holder, inside of the spout, and bin liner.
5) Rinse the parts and areas sanized in step 4
thoroughly with clean water.
6) Replace all removed parts in their original and
correct posions.
CHOKING HAZARD: Ensure all components,
fasteners, and thumbscrews are securely in place. Make sure
that none have fallen into the storage bin.
7) Make sure at least 10 minutes have elapsed since you
poured the sanizing soluon over the extruding
head, then move the control switch to the “ICE”
posion.
8) Allow the appliance to make ice for 20 minutes, then
move the control switch to the “DRAIN” posion.
9) Allow the water system to drain for 1 minute.
10) Move the control switch to the “ICE” posion.
11) Aer the gear motor starts, move the control switch
to the “DRAIN” posion.
12) Allow the water system to drain for 1 minute.
13) Move the control switch to the “OFF” posion.
5. Sanizing Procedure - Final
1) Using a clean funnel and hose, pour 1 qt (1 l) of
sanizing soluon over the extruding head. Allow the
appliance to sit for 10 minutes before operaon.
2) Move the control switch to the “ICE” posion.
3) Allow the appliance to make ice for 20 minutes, then
move the control switch to the “DRAIN” posion.
4) Allow the water system to drain for 1 minute.
5) Move the control switch to the “ICE” posion.
6) Aer the gear motor starts, move the control switch
to the “DRAIN” posion.
7) Allow the water system to drain for 1 minute.
8) Move the control switch to the “ICE” posion and
allow the appliance to run. Check for leaks.
9) Aer 30 minutes, move the control switch to the
“OFF” posion.
10) Pour warm water into the storage bin to melt all of the
ice, then clean the storage bin liner, door liner, and
door gasket with a neutral cleaner. Rinse thoroughly
aer cleaning.
11) Move the control switch to the “ICE” posion to start
the automac icemaking process.
DANGER
!
CAUTION

Perlick H80CIMS-AD Specifications

General

Brand	Perlick
Model	H80CIMS-AD
Category	Ice Maker
Language	English