Bushing Series Service Manual
16.
Multiple Units Only
Repeat steps 10 - 13
using continental gears
in step 12.
17.
Position port end cover
over gear journals and
dowel pins. Gently tap
until the parts are
together.
18.
Place 4 washers on the port end cover. Thread 4 clean and dry fasteners
into the shaft end cover, and tighten alternately in a diagonal pattern.
Rotate the drive shaft with vise grips and torque to specification shown in
table below.
Guide for Replacing Parts
Thrust Plates
Replace plates if scored, eroded, pitted, or
discolored from heat.
Gears
Replace if any scoring on journals is found. Also
fretting, nicking, scoring, or grooving of teeth
surfaces.
Gear Shafts
Same as gears, but also replace if any wear is
found in seal area. Also replace if any wear on
splines or keyway is found.
Gear Housing
Replace if wear exceeds 0.005” below bore.
Dowel Pins
If the dowel pin is loose in the casting, either the
dowel pin or casting must be replaced
Bushings
Replace if scoring, discoloration, or signs of copper
showing through. If gear set is replaced, the
bushings should also be replaced.
To Next Page
Loading...