What to do if LEDs are flashing on Permobil VoltPro Battery Charger?
If the LEDs on your Permobil Battery Charger are flashing, it indicates an error during charging or that the charger has overheated. First, try charging again. If the error continues, contact Permobil. If you suspect overheating, disconnect the charger and allow it to cool down completely before attempting to use it again.
Why only LED illuminates on Permobil VoltPro?
If only the LED illuminates when your Permobil Battery Charger is connected to both the wheelchair and a power outlet, it could be that the charger isn't detecting the wheelchair's batteries. Ensure the charging connector is properly connected to the wheelchair. Also, check the wheelchair’s main circuit breaker (refer to the wheelchair’s user manual for details). If problems persist, contact Permobil for repair.
How to fix Permobil VoltPro when LED does not illuminate?
If the LED on your Permobil Battery Charger does not illuminate, it could be due to several reasons. First, check that the charger is properly connected to a power outlet. Second, verify that there isn't a main power failure in your house. If neither of these is the cause, the battery charger may have an internal error, and you should contact Permobil for repair.
General| Brand | Permobil |
|---|---|
| Model | VoltPro |
| Category | Battery Charger |
| Language | English |
Product Warranty Information sets forth warranty conditions. See permobilus.com/support/warranties/ for details.
Product fulfills EN 12184, IEC 60335, and ISO-7176 standards for wheelchairs and chargers.
Contact Permobil for assistance with any technical problems encountered with the product.
Contact Permobil by phone or e-mail if any incidents occur during product use.
Contact Permobil for information regarding current scrapping and recycling agreements.
Includes off-board battery charger, connector holder, and screw. Plug type varies by market. Connector attaches to wheelchair.
Explains WARNING! and CAUTION! symbols indicating potential hazards, injury, or property damage.
Warnings about explosive gases during charging. Ensure ventilation and disconnect power before connecting/disconnecting battery.
Explains information on warning labels including item number, S/N, input/output, battery compatibility, and symbols like 'Read instructions'.
Steps for charging: connect charger to wheelchair, then to outlet. Disconnect in reverse order when complete.
Explains LED indicators for charger status, battery level, charger setting, and errors.
Recommendations for charging: room temperature, correct setting, continuous charging after full, daily full charge, check indicator or app.
Details output current, voltage, input range, power, insulation class, efficiency, battery capacity/types, and cooling method.
Specifies housing material (PC/ABS), dimensions (width, height, depth), cable lengths, and product weight.
Defines acceptable operating conditions: ambient temperature, relative humidity, and atmospheric pressure ranges.
Specifies acceptable storage and shipping conditions for ambient temperature, relative humidity, and atmospheric pressure.
To Next Page
