To Next PageTo Next Page
Need help?Do you have a question about the Perry 1GA 50917MET/P and is the answer not in the manual?
Provides critical safety information and precautions for product use and installation.
Outlines periodic checks, annual inspections, and recommended replacement intervals for the detector.
Details electrical supply requirements and the maximum capacity of the relay contacts.
Specifies the environmental protection rating (IP) and electrical insulation class of the detector.
Defines the suitable operating temperature, humidity, and the types of gases the detector is designed to detect.
Explains the meaning of Green, Yellow, and Red LEDs and the buzzer for operational status and alarms.
Describes the appliance's operational status indicators during warm-up and normal detection modes.
Details how the detector signals gas presence and triggers alarms with LEDs and audible alerts.
Explains how the detector indicates internal faults or breakdowns via specific LED and buzzer patterns.
Provides essential safety instructions and immediate actions required in case of a gas leak or alarm.
Emphasizes compliance with national standards for gas equipment and general installation practices.
Provides specific guidance on mounting height and distance from gas appliances for accurate detection.
Shows the physical dimensions of the detector for surface and semi-flush mounting options.
Lists important 'dos and don'ts' to ensure proper functioning and prevent damage or false alarms.
Explains the semi-flush mounting procedure, including the use of an optional support and fixing points.
Describes the surface mounting method, detailing the base, wire passages, and fixing slots.
Illustrates the process of fixing and removing the detector from its mounting support or base.
Details the steps for connecting the detector to the mains supply and controlled devices, emphasizing qualified personnel.
Provides example diagrams for connecting normally closed (NC) and normally open (NO) solenoid valves.
Instructs on how to record the installation and mandatory replacement date using adhesive labels.
Guides the user on performing operational tests using test gas to verify alarm and relay functions.
Provides guidance on the proper disposal of electrical and electronic equipment according to EU directives.
States the manufacturer's right to implement technical and manufacturing changes without prior notice.
General| Gas Type | Methane |
|---|---|
| Output | 4-20 mA |
| Protection | IP66 |
| Detection Range | 0-100% LEL |
| Operating Temperature | -20°C to +50°C |
| Weight | 1.5 kg |
| Sensor Type | Catalytic |
