ROOF RACK INSTALLATION INSTRUCTIONS (ALL RAIL LENGTHS)
1549 US Highway 21 South
Sparta, NC 28675
336-372-2545
customerservice@perrycraft.com
www.perrycraft.com
ROOF RACK INSTALLATION INSTRUCTIONS
(ALL RAIL LENGTHS)
Before contacting/returning this product to your place of purchase,
contact Perrycraft, Inc.® at 336-372-2545 for any technical
questions, problems, missing parts, etc., upon opening your
product and verifying all parts are present.
RETURNS: Any product to be returned must be returned to the place of
purchase, and is subject to the seller’s returns policy. DO NOT return to
Perrycraft unless instructed to do so in writing.
IMPORTANT NOTES:
RACK LOCATION: Perrycraft’s products are manufactured to be installed
into the skin of the roof panel of vehicles. They are not designed to line up
or be installed at the factory fitment points available on some vehicles.
INSTALLATION HARDWARE: The included hardware pack contains screws
for securing this rack to a sheet metal roof or metal surface. To install this
rack on fiberglass or composite camper tops, tonneau covers, or Jeep
©
tops,
please contact your seller to purchase hardware pack HWDSTC-UV, or call
336-372-2545 to purchase directly from Perrycraft, Inc.®
SIDE RAIL CURVATURE: Perrycraft, Inc.® manufactures racks and rails that
are size specific, not vehicle specific. Therefore, the bow of the rails (front
to back) may need adjusting. Place the rails (without the stanchions) on the
roof in the desired location. Ideally, the rails should match the roof
curvature. The ends of the rails should touch the roof and the center should
be no more than 3/16” off the roof surface. The rails can be adjusted (more
bow or less bow) by placing the ends of the rails on supports and either
pressing down from the top (to take away bow), or pressing down from the
bottom (to add more bow). Rails are heat treated aluminum, therefore,
very strong. Several attempts of adjustment may be required to get the
correct curvature.
ITEMS NEEDED (NOT INCLUDED)
Measuring Tape
Masking Tape
Marker
Drill
1/8” and 3/16” Drill Bits
Phillips Screwdriver
2
To Next Page
Need help?
General