Please Read this Manual Carefully before Using
Thank you for purchasing the anti bark collar
PET681VVibration
Anti Bark Collar User Manual
Product Manual
Step1
Step2
Step3
1st bark: Progressive warning beeps for 1.5 seconds
2nd bark: Progressive warning beeps for 2.5 seconds
3rd bark: Sound for 4 seconds+Vibration for 0.5 seconds
4th bark: Sound for 4 seconds+Vibration for 1 seconds
5th bark: Sound for 4 seconds+Vibration for 1.5 seconds
6th bark: Sound for 4 seconds+Vibration for 2 seconds
7th bark: Sound for 4 seconds+Vibration for 2.5 seconds
8th bark: Sleep Mode for Safety (for 1 minute)
There are total 7 sensitivity levels. The 4th level is set
automatically after installing the battery.
DO NOT PUT THE COLLAR ON YOUR DOG WITHOUT
FIRST TESTING IT UNDER ANY CIRCUMSTANCES.
Make sure you have a good battery before testing.
Safety warning - please read before using:
Do not leave collar on dog for more than 6-10 hours to
avoid pressure necrosis due to the probes touching the
Do not put on dog when dog is sleeping, laying or unattended .
Make sure probes are a finger width apart from dog’s neck
(stick your finger between dog’s neck and the probes to test)
Important Note:
When the collar is fitted correctly, IT DOES NOT MOVE.
You can slide just one finger under the collar.
If it is NOT FITTED CORRECTLY, it will go off randomly
and will not work when your dog barks.
Introduction:
The anti-bark collar stops barking with progressively
increasing sound and vibration which is controlled b y a
microprocessor distinguishing your dog’s bark from other
environmental noises and automatically deliver s so un d
and vibration after each bark.
skin.
Operating Instructions:
Our PET681V is almost completely automatic. Just install
a 6 volt alkaline battery, adjust the strap to the size of your
dog’s neck and the PET681V automatically begins doing
its job.
PRINCIPLES OF OPERATION:
Anti bark collar has 7 correction levels, which deliver
different sound and vibration combinations:
1. BATTERY INSTALLATION:
1. Remove the decorative cover.
2. Pull the strap loose.
3. Remove the battery cover.
4. Insert the battery (6 volts) between the “clip”[positive
End(+)] and “spring”[negative(-)] contacts.
The collar will be automatically set to the 4th sensitivity
level (total 7 sensitivity levels).
1
2
3
4
Screw probes on electrodes
Install the baery
Remove the faceplate
Blow into the s mal l hole
Red LED light remains on
Beep sound
Vibrate
To Next Page
Need help?
General