HD2000
PRODUCT MANUAL
LEAKING INSTRUCTIONS – Visit Petratools.com/start for full instructions and videos.
INSTRUCTIONS – FOLLOW CLOSE TO PREVENT LEAKING
TO PREVENT LEAKING: Whenever you have water being sprayed there is a chance for leaking at any connection point. Use the
included PTFE Teflon Tape at all connection points where leaking may occur.
PTFE TAPE: Apply PTFE thread tape (“Plumber’s tape”) to any connect piece that is leaking.
It is common for the nozzle, handle and wand connections to leak because of the high pressure of
the sprayer. Applying PTFE tape liberally around the threaded connections can help reduce leakage.
(1 roll is provided, but more tape or “plumber’s putty” can be found at your local store or online.)
TIGHTEN CONNECTIONS: Leaking commonly occurs when the nozzle pieces have not been fully
tightened. Connections can come loose over time, so check your nozzle connections and re-tighten
before each use and whenever you switch out your nozzles.
Visit www.petratools.com/start for
information on all nozzle types,
their common uses, and for
additional nozzle attachment
selections we will add over time.
INCLUDED NOZZLES
Triple Head Blue Nozzle
Different head focus nozzle that will give you a nice spread mist.
Red Cone Nozzle
Will give you a four-spray pattern. Twist tight to make a fine mist that can reach up to 10-15 ft.
Orange Angle Flower Top Nozzle
Nice angle bent nozzle that will give you a four-spray shot up to 10 ft and a mist when tighten.
Single Yellow Head Nozzle
Single head nozzle for a flat fan spray.
Angled Black Nozzle
Will give you a fine mist when tighten up and a single stream that goes up to 15-20 ft when loosen.
Questions/Issues
with your product?
We’re here to help!
Please visit the page
petratools.com/support
to get the fastest resolution to your problem.
Toll free: 1-800-613-6889
Contact us: support@petratools.com
Website: www.petratools.com
To Next Page
