Leaking Instructions
Line Flush Bulb
HD5000 Reel Cart PetraFlow
Nozzles
Volume nozzle that lets a significant
amount of solution out. Twist top to
adjust spray for different uses.
Orange Cone Nozzle
Double head mist nozzle that lets you
cover a large area with a medium fine
mist.
Double Head Nozzle
Single head nozzle for a very fine mist.
Single Head Nozzle
Single head nozzle for a flat fan spray.
Single Yellow Head Nozzle
Will give you a fine mist when tighte-
ned up and a single stream that goes
up to 15-20 ft when loosened.
Angled Black Nozzle
From fine mist to long distance spray.
Not advisable to be used with acid &
bleach solution!
Brass Nozzle
TO PREVENT LEAKING: Whenever you have water being sprayed there is a chance for leaking at
any connection point. Use the included PTFE Teflon Tape at all connection points where leaking
may occur.
PTFE TAPE: Apply PTFE thread tape (“Plumber’s tape”) to the connecting points on your sprayer.
If you get a le ak it can be due to high pressure, no worries, just use the enclosed teflon tape
and you will be all set! Applying PTFE tape liberally around the threaded connections can help
reduce leakage.
(1 roll is provided, but more tape or “plumber’s putty” can be found at your local store or online.)
TIGHTEN CONNECTIONS: Leaking commonly occurs when the nozzle pieces have not been
fully tightened. Connections can come loose over time, so check your nozzle connections and
re-tighten before each use and whenever you switch out your nozzles.
For your convenience, we have included a free line
flush bulb. This bulb helps clear lines and re-prime
your unit after long periods of inactivity. It’s easy to
use - just insert into the hose, valve handle, or wand
and squeeze to force air forward. This will help clear
any blockages and prime the pump.
To Next Page
Loading...