Assemble Collar
To assemble the collar, first measure your pet’s neck, mark the appropriate
length, and cut off any excess material. Seal the edge of the cut by taking a
match or lighter and melt the frayed edge.
Note: When cutting off the excess collar, be sure to leave enough slack for
your dog’s growth.
Deluxe Remote Trainer Owner’s Guide
Identifying the Components
Long and
Short Probes
9V Alkaline
Battery (included)
3V Lithium
Batteries (included)
Deluxe Big Dog Trainer
Deluxe Little
Dog Trainer
2
Transmitter
Step 1: Thread slide buckle onto the
collar first. See Diagram 1.
Step 2: Thread end of the collar up
through the buckle. See Diagram 2.
Step 3: Thread excess collar through the
slide buckle to hold it in place. This will
allow you to adjust your pet’s collar as he
grows. See Diagram 3.
Diagram 1.
Diagram 2.
Diagram 3.
ENGLISH
400-422-11/A 2/24/00, 12:35 PM2-3
To Next Page
Loading...
