Petsafe Simply Clean - Testing and FAQs; Testing the Litter Box; Frequently Asked Questions

10 Customer Care Center +1 (800) 732-2677
Testing the Litter Box
The Simply Clean
®
Automatic Litter Box cleans for 30 minutes then stops for 30 minutes, making one full rotation every 1½ hours. The bowl moves
very slowly and is whisper-quiet, so your cat will not notice the movement.
FREQUENTLY ASKED QUESTIONS
QUESTIONS ANSWERS
Will the continuous
movement of the
Simply Clean
®
Automatic
Litter Box scare my cat?
No. The Simply Clean
®
Automatic Litter Box has no exposed moving parts, and the litter bowl rotates at a
rate of one rotation every 1½ hours. It is whisper-quiet and will not startle or disturb your cat.
Does the Simply Clean
®
Automatic Litter Box
reduce odor?
Yes. Since waste is continuously sifted and moved to the covered waste bin, you will notice a considerable
reduction in odor compared to other litter boxes. To reduce odors even more, you can add some fresh litter
and baking soda to the bottom of the lined or unlined waste bin. The carbon filter in the conveyor hood will
also help to reduce odors in the waste bin area.
Do I need to purchase a
special brand of cat litter?
No. Any clumping, scoopable, clay cat litter will work.
Do I need to purchase special
waste bin bags?
No. You can use any small plastic waste/trash bag or no bag at all. If you don’t use a bag, you might need
to occasionally wash the waste bin.
How often do I need to
empty the waste bin?
Depending on the level of use and how many cats you have, we recommend that you empty the waste bin
when it is nearly full, or every other day, to better reduce odors.
Will I use more litter than my
traditional litter box?
No. The Simply Clean
®
Automatic Litter Box uses less litter than most traditional litter boxes, since there is
no daily scooping and refilling.
1
1. To test if the litter box is rotating properly, place one piece of
adhesive tape on the base of the unit and one piece of tape on the
bowl of the unit.
2
2. After several minutes, the two pieces of tape should be several
inches apart. Remove the tape when finished testing.