Petzl Croll - Function Test

3
B16_CROLL_B165000K (170610)
Installing the rope Function test
Ascending the rope
7 8
9
Pull the safety catch down and lock it on the frame of the device.
The cam then stays in the open position.
Put the rope into its place. Pay attention to the Up/Down indicator.
Push the safety catch so that the cam presses against the rope. In
this position the safety catch helps prevent involuntary opening
of the cam.
Removing the rope
Move the device up the rope while pulling the safety catch down
and out.
Each time the device is installed onto the
rope, verify that it jams.
Use the CROLL
and another
hand rope
clamp (e.g.
ASCENSION
handled rope
clamp) with
a foot-loop.
Always attach
yourself to
the second
ascender with
an appropriate
lanyard.
Angled traverse
situation
When on an angled
traverse, guide the
horizontal part of the rope
so that it is as vertical as
possible to reduce the risk
of accidentally opening
the cam.
STOP!
STOP!
1 2 3
and another
ASCENSION
handled rope
clamp) with
a foot-loop.
Always attach
ascender with
an appropriate
Angled traverse
situation
When on an angled
traverse, guide the
horizontal part of the rope
so that it is as vertical as
possible to reduce the risk
of accidentally opening
the cam.