EN
These Instructions for Use are inseparable from the
international regulations found in the MyPetzl Light
application and at Petzl.com.
Nomenclature
(1) Light sensor, (2) White LED for spot beam, (2
bis) White LED for flood beam, (2 ter) Red LED,
(3) Rechargeable battery, (4) Port with protective
cover for USB A/Micro B cable, (5) USB A/Micro
B cable, (6) Energy gauge or Bluetooth activation
indicator (blue).
REACTIVE LIGHTING
technology
The lamp features REACTIVE LIGHTING
technology. The lamp's integrated light sensor
instantly and automatically adapts the shape
and power of the beam. REACTIVE LIGHTING
technology gives you the benefit of optimal lighting
for your activities, while ensuring the minimum
chosen battery life.
For biking, use your lamp with CONSTANT
LIGHTING technology (risk of switching off with
REACTIVE LIGHTING technology).
Lamp operation
Switching on & off, selecting
When you turn on your lamp, it normally turns on
with REACTIVE LIGHTING technology (if you lock
your lamp after using red light it normally turns
on in red).
When switching between REACTIVE and
CONSTANT technologies, the lamp always turns
on in MAX AUTONOMY mode.
With REACTIVE LIGHTING technology:
- When the sensor detects an area with
sufficient light, your lamp will blink dimly for two
minutes, then automatically turns off to conserve
rechargeable battery life.
MyPetzl Light Bluetooth® mobile
application - customizing your lamp.
Access to the battery's charge level; to the lamp's
remaining burn time in hours and minutes; to
customizing lamp performance depending on
the activities, according to six preset profiles:
multi-activity, camping-backpacking, trail running,
caving, trekking and mountaineering.
By default, the lamp comes with Bluetooth
activated.
The Bluetooth® mark and logo are registered
trademarks of Bluetooth SIG Incorporated and are
used under license by Petzl.
Attention: requires iOS 7 or later, or Android 4.3
or later.
Charging the
rechargeable battery
The lamp comes with a Petzl Li-Ion rechargeable
battery. Capacity: 1800 mAh
Charge it completely before first use.
Use only a Petzl ACCU REACTIK+
rechargeable battery.
In general, Li-Ion rechargeable batteries lose 10
% of their capacity each year. After 300 charge/
discharge cycles, they still have about 70 % of their
initial capacity.
Charging the battery
Recharge only with a USB 5 V charger, for
example:
- Computers (they must be turned on and in use).
- Solar panels with a USB 5 V output (preferably
panels delivering at least 5 W or 1 A for faster
charging). Warning, protect the sensor's lens
from overexposure to the sun to avoid damaging
the sensor.
- Portable power supply.
Warning
Recharge only with a USB cable of less than 3
meters in length. The charger's output voltage
must not exceed 5 V. Use only a CE/UL approved
charger.
The USB external power supply connected to your
product must be a SELV type and be a limited
power source as defined in chapters 2.2 and 2.5
of the standards IEC 60950-1 ed.2.2 and EN
60950-1 : 2006+A11 : 2009+A1 : 2010+A12 :
2011+A2 : 2013.
When charging, the power plug should remain
easily accessible.
Recharge time
Recharge time is 5 hours with the USB charger,
or a computer. Attention, if many USB devices are
connected to your computer, the charging time can
increase (up to 24 hours).
While charging, the energy gauge blinks green,
changing to steady green when charging is
complete, and steady red in case of malfunction.
Replacing the rechargeable battery
Use only a Petzl ACCU REACTIK+ rechargeable
battery. Using another type of rechargeable battery
can damage your lamp. Do not use another type of
two conditions : (1) this device may not cause
harmful interference, and (2) this device must
accept any interference, including interference
that may cause undesired operation. Note : This
equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instruction, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct interference
by one or more of the following measures :
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on
circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio /TV
technician for help.
IC : Under Industry Canada regulations, this radio
transmitter may only operate using an antenna
of a type and maximum (or lesser) gain approved
for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the
antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.)
is not more than that necessary for successful
communication.
rechargeable battery.
For use in remote areas, the rechargeable battery
can be replaced by a standard battery case (not
included).
General info on Petzl
lamps and batteries
A. Rechargeable battery precautions
Warning, incorrect use can damage the
rechargeable battery.
- Do not submerge the rechargeable battery
in water.
- Do not put the rechargeable battery in a fire.
- Do not destroy the rechargeable battery, it can
explode or release toxic materials.
- If your rechargeable battery is damaged, do not
dismantle it or change its structure.
- If your rechargeable battery is deformed or
cracked, dispose of it in a recycling bin.
B. Lamp precautions
The lamp is not recommended for children.
Eye safety
The lamp is classified in risk group 2 (moderate
risk) according to the IEC 62471 standard.
- Do not look directly at the lamp when lit.
- The optical radiation emitted by the lamp can
be dangerous. Avoid aiming the lamp's beam into
another person's eyes.
- Risk of retinal damage from the emission of blue
light, particularly in children.
Electromagnetic compatibility
Meets the requirements of the 2004/108/CE
directive on electromagnetic compatibility.
Warning, an avalanche beacon in receive (find)
mode can experience interference when in
proximity to your headlamp. In case of interference
(indicated by static noise from the beacon), move
the beacon away from the headlamp.
C. Cleaning, drying
If used in a damp environment, remove the battery
from the lamp and dry the lamp case with the USB
port cover open. In case of contact with seawater,
rinse the lamp in fresh water and dry it.
If your lamp is dirty, clean it with a damp cloth
and let it dry.
Do not allow chemicals to come into contact with
your lamp.
D. Storage
For long-term storage, recharge the rechargeable
battery (repeat every six months) and remove
the battery from the lamp. Avoid allowing your
rechargeable battery to discharge completely. Be
sure to store your rechargeable battery in a dry
place. The ideal storage temperature is between
20 and 25° C.
After 12 months in these conditions without use,
the rechargeable battery will be discharged.
E. Protecting the environment
F. Modifications/repairs
Prohibited outside of Petzl facilities, except
replacement parts.
G. Questions/contact
The Petzl guarantee
This lamp is guaranteed for 3 years against any
defects in materials or manufacture (except the
rechargeable battery, which is guaranteed for one
year or 300 cycles). Exclusions from the guarantee:
more than 300 charge/discharge cycles, normal
wear and tear, oxidation, modifications or
alterations, incorrect storage, poor maintenance,
damage due to accidents, to negligence, or to
improper or incorrect usage.
Responsibility
Petzl is not responsible for the consequences,
direct, indirect or accidental, or any other type
of damage befalling or resulting from the use of
its products.
Marking
(a) Model.
(b) Rechargeable battery serial number.
(c) International certifying bodies.
(d) Turning on or off.
(e) Conforms to European requirements: Petzl
declares that this product conforms to the essential
requirements and other relevant provisions of the
1999/5/CE, 2004/108/CE, 2006/95/CE Directive.
The declaration of conformity can be found at
Petzl.com
(f) Product designed and manufactured with high
quality materials and components that can be
recycled and reused.
(g) Management of electrical and electronic
equipment waste.
FCC/IC informations
The device complies with FCC and IC radiation
exposure limits set forth for general population.
This device must not be co-located or operating in
conjunction with any other antenna or transmitter.
The device complies with Part 15 of the FCC Rules
and with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following
E925070A (040815)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
