PEUGEOT 2008 User Manual

174
Practical information
On vehicle fitted with HDi engines, the fuel
system must be primed if you run out of fuel.
For versions with a manual priming pump,
refer to the drawing of the corresponding
underbonnet view.
If the tank on your vehicle is fitted with
a misfuel prevention device, refer to the
corresponding section.
Running out of fuel (Diesel)
If the engine does not start first time,
don't keep trying. Start the procedure
again from the beginning.
F Add at least 5 litres of Diesel fuel to the
tank.
F Switch the ignition on (without starting the
engine).
F Wait around 6 seconds and switch off the
ignition.
F Repeat the operation 10 times.
F Operate the starter motor to start the
engine.
1.6 litre BlueHDi engines
F Add at least 5 litres of Diesel fuel to the
tank.
F Open the bonnet.
F If necessary, unclip the styling cover for
access to the priming pump.
F Squeeze and release the priming pump
repeatedly until resistance is felt (there
may be resistance at the first press).
F Operate the starter to start the engine
(if the engine does not start at the first
attempt, wait around 15 seconds before
trying again).
F If the engine does not start after a
few attempts, operate the priming pump
again then start the engine.
F Refit the styling cover and clip it in place.
F Close the bonnet.
1.6 litre e-HDi 92 engine

PEUGEOT 2008 Specifications

General

Brand	PEUGEOT
Model	2008
Category	Automobile
Language	English