26-05-2003
RADIO
Notes on radio reception
Your car radio is subject to phenomena which do not affect domestic radio sets. Both AM (MW/LW) and FM reception are
subject to various forms of interference. This is no reflection on the quality of the equipment, but is due to the nature of the
signals and the way in which they are transmitted.
On MW/LW, interference may be noticed when passing under high voltage power lines or bridges, or in tunnels.
On FM, interference may be the result of increasing distance from the transmitter, deflection of the signals by obstacles
(mountains, hills, buildings, etc.), or of being in an area which is not covered by a transmitter.
Selecting radio mode
Audio RB3: press button "SRC" several times in succession.
Audio RD3: press button R.
Selecting a waveband
Audio RB3: briefly press the "BND/AST" button to select the FM1, FM2, FMast and AM wave-
bands.
Audio RD3: briefly press button R to select the FM1, FM2, FMast and AM wavebands.
Automatic station search
Briefly press button L or N to search for the station immediately above or below. By continuing to press
the button in the direction selected, you will obtain continuous scrolling of the frequency.
The scrolling stops at the first station found as soon as the button is released.
If the TA traffic information programme is selected, only stations broadcasting this type of pro-
gramme are selected.
Searching for a station occurs first in "LO" sensitivity (selection of the most powerful transmitters) during scanning of the
waveband, then in "DX" sensitivity (selection of the weakest and most distant transmitters).
To make a direct search in "DX" sensitivity, press button L or N twice.
YOUR 206 IN DETAIL
48
To Next Page
Loading...
Need help?
General
