EasyManuals Logo

PEUGEOT 407 2008 User Manual

PEUGEOT 407 2008
204 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #104 background imageLoading...
Page #104 background image
7
SAFETY
91
SEAT BELTS
Detection of fastening of the front
seat belts
When the ignition is switched on ,
if a front passenger has not fastened
his seat belt and if the vehicle speed
is below 13 mph (20 km/h) , you are
warned by lighting of the seat belt
warning light .
The warning light switches off when the
seat belt(s) concerned is(are) fastened.
If the vehicle speed is above 13 mph
(20 km/h) , you are warned by ash-
ing of the seat belt warning light , an
audible signal and a message on the
multifunction display locating the un-
fastened seat belt(s).
Front seat belts with
pre-tensioner and force
limiter
In the event of a serious front
impact, the pre-tensioning system in-
stantly tightens the seat belts rmly
against the bodies of the occupants.
The pre-tensioning seat belts are
armed when the ignition is on.
The force limiter reduces the pressure
of the seat belt against the chest of
the occupant, so increasing his pro-
tection.
Rear seat belts
The rear seats are all tted with a
three-point inertia reel seat belt.
The rear side seat belts have a force
limiter and may be tted with a pre-
tensioning inertia reel.
To fasten the seat belts
Pull the strap, then insert the
tongue into the buckle.
Check that the seat belt is secured
correctly by pulling the strap.
To unfasten the seat belts
Press the red button on the buckle.
Before folding the seat back, pull the
strap and insert the seat belt tongue
into the buckle. This precaution will
ensure that each seat belt is in place
when the rear seats are lifted again.
Note: a bag or an animal
placed on the front passenger
seat may trigger the lighting of
the warning light.
The audible signal ceases and the
warning light switches off when the
seat belt concerned is fastened.
After two minutes without any action
on the seat belts, the ashing warning
light remains on permanently and the
audible signal ceases. All of the warn-
ings cease when a door is opened or
when the engine is switched off.
Front seat belt height adjustment:
To lower the attachment point,
squeeze control 1 and slide it
downwards.
To raise the attachment point, slide
control 1 upwards.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the PEUGEOT 407 2008 and is the answer not in the manual?

PEUGEOT 407 2008 Specifications

General IconGeneral
BrandPEUGEOT
Model407 2008
CategoryAutomobile
LanguageEnglish

Related product manuals