161
QUICK HELP
8
Puncture
PUNCTURE REPAIR KIT Repairing the tyre
- Apply the parking brake.
- Unscrew the tyre valve cap, remove the
filling hose B and screw the ring E onto
the valve.
- Start the engine.
- Insert the connector G into the nearest
power socket on the vehicle.
- Switch on the compressor by placing the
switch F in position "I" (on).
- Inflate the tyre to a pressure of 5 bar.
To obtain a more accurate reading, you are
advised to check the pressure value on the
pressure gauge H, with the compressor off.
- Check that the switch F on the
compressor is in position "0" (off).
This temporary puncture repair kit stowed
in a bag located in one of the front door
pockets.
It consists of:
- a cartridge A, containing the sealant
fluid, equipped with:
● a filling hose B,
● a sticker C indicating "max. 80 km/h",
which the driver must affix in full view
(on the dashboard) after repairing
the tyre,
- a quick guide to use of the repair kit,
- a compressor D equipped with a
pressure gauge and unions,
- adaptors, for the inflation of various
items.
To Next Page
Loading...
Need help?
General
