Need help?Do you have a question about the PEUGEOT ELYSEO 125 and is the answer not in the manual?
General| Engine Type | Single cylinder, 4-stroke |
|---|---|
| Front Tyre | 120/70-12 |
| Rear Tyre | 130/70-12 |
| Front Suspension | Telescopic fork |
| Cooling System | Air cooled |
| Transmission | Automatic |
| Brakes | Front: Disc, Rear: Drum |
Factors affecting catalyser and exhaust lifespan, seal checks.
Use unleaded fuel, recommended lubricants, avoid additives.
Handling misfiring or power loss, contacting dealer.
Switch off ignition only when the engine runs at idle speed.
Contact dealer for starting problems.
Exhaust heat caution, avoid flammable materials.
Indicates headlight status.
Alerts for low engine oil pressure, requires immediate stop.
General warning or status indicator.
Indicates antitheft system activation.
Shows fuel level and reserve status.
Monitors engine coolant temperature, red zone warning.
Displays vehicle speed in km/h or mph.
Displays time, date, and offers setting functions.
Tracks total distance and daily travelled distance.
Controls engine stop, electrical contact, and steering lock.
Engages the electric starter motor.
Manages headlight, sidelight, and off modes.
Selects between high beam and low beam.
Activates left and right turn indicators.
Presses the horn button.
Procedure to open and close the saddle.
Access to helmet housing and petrol tank; no aerosols.
Use unleaded petrol 95/98, no additives, no contaminants.
Locates engine oil filler neck; use 4-stroke oil.
Lists screwdriver, spark plug wrench, shock absorber wrench.
Check oil level using peephole when engine is cold.
Draining old oil, replacing plug and filter, topping up.
Specifies oil capacity with and without filter change.
Procedure for changing the oil filter with engine oil.
Check coolant level in expansion vessel when cold.
Do not use with low coolant; risk of damage; contact dealer.
Check electrolyte level, use demineralized water.
Explosive gases, ventilation, eye protection, acid caution.
Connect red wire to (+) terminal, green wire to (-) terminal.
Fuses protect electrical circuits; replace with same rating.
Details bulb types for headlights, brake lights, signals.
Procedure for changing headlight and indicator bulbs.
How to adjust headlight vertical orientation.
Procedure for changing rear light and indicator bulbs.
Procedure for replacing the number plate light bulb.
Steps for starting the engine using the electric starter.
Avoid running engine in closed rooms due to exhaust gases.
Turn off ignition at idle speed, remove key for theft prevention.
Instructions for using the central stand and safety.
Caution when using the side stand with automatic lift.
Importance of break-in for engine life and performance.
Steps to start, drive, throttle control, and deceleration.
Gearbox oil topping up or renewal by dealer.
Advises correct plug type and tightening procedure.
Procedure for removing, cleaning, and refitting the air filter.
Monitor brakes, use dealer, original parts, fluid type.
Coordination of throttle and brakes, steep gradients, continuous braking.
Procedure to adjust rear brake lever clearance.
Recommended cold tyre pressures for front and rear.
Dangers of worn tyres and incorrect inflation.
Scooter fitted with tubeless tyres; use dealer for repair/replacement.
Warning against fitting inner tubes or using rims incorrectly.
Handle parts carefully, avoid actuating brake lever without wheel.
Steps to remove the front wheel.
Steps to refit the front wheel and torque specs.
Steps to remove the rear wheel, including shock absorber and arm.
Steps to refit rear wheel and torque specs.
Procedure to remove the anti-theft device using the key.
How to secure the scooter with the anti-theft cable.
Procedure to store the anti-theft device neatly on the scooter.
Avoid contact with ground, protect lock from water.
How the electronic transponder and antenna work for starting.
Advise not to use the Master Key for everyday use.
Overall length, width, height, wheelbase, and weight.
Oil tank, petrol tank, bore, stroke, compression, displacement.
Primary/final gear, battery, generator, and fuse specifications.
Fork oil, engine oil, brake fluid, final drive, fuel, coolant capacities.
Engine size, cylinders, power, valve clearance, idle speed.
Tyre pressure specs, spark plug type, and electrode gap.
To Next Page