PF Power MIW-POWER-PRO-PFP

To Next Page

MIW-POWER-PRO-PFP INSTALLATION INSTRUCTIONS

STEP 1:

Select a location close to the equipment. In the case of a at panel

display, the recommended location is one that is behind the device

and hidden from view once the Plasma TV is mounted. Cut a 4”

wide by 3 3/4” high hole in the wall for the outlet box.

STEP 2:

Run the building wire (e.g. Romex) through a rear opening in

the outlet box (not included). No more than 1” of wire sheath

should extend into the outlet box. 3” of wire should be able to

extend beyond the opening of the outlet box. Install the outlet

box in the hole.

STEP 3:

Strip building wire. Using the included wire nuts, rst connect

the ground wires - green insulated on the MlW-Power and bare

copper on the building wire. Then connect the neutral wires

(white), then the hot wires (black).

STEP 4:

Neatly fold the AC wires as you install the Max In-Wall in the

outlet box and secure with the included screws.

STEP 5:

Turn the power on to the circuit. The blue Power indicator

should light up, indicating the outlet is ready for use.

NOTES:

In the event of a hazardous voltage situation, the red Unsafe

Voltage indicator will blink until the voltage returns to a safe level.

(Outlet boxes

not included)

INS00840 REV A 11/07

CAUTION:

Only for use with 15 Amp circuits utilizing a minimum of 14 AWG.

Make sure the circuit is not live before installation. If you are unsure how

to perform this task, please contact an electrician.

Signal Protection Module Usage:

PF Power In-Wall signal protection modules (sold separately),

while not necessary for surge protection in the Max In-Wall

Power-Pro, may be used to provide a clean looking interface for

the signal lines. When used in the proper manner the modules

also provide total protection to the connected equipment.

Need help?

Do you have a question about the PF Power MIW-POWER-PRO-PFP and is the answer not in the manual?

Summary

Installation Steps

Step 1: Location Selection and Hole Cutting

Select a location, cut a 4" wide by 3 3/4" high hole for the outlet box.

Step 2: Running Building Wire

Run building wire through the outlet box, ensuring 1" sheath and 3" wire extension.

Step 3: Wire Connections

Connect ground, neutral (white), and hot (black) wires using included wire nuts.

Step 4: Securing the Outlet

Neatly fold AC wires and secure the Max In-Wall outlet with screws.

Step 5: Power On and Indicator Check

Turn on the circuit; the blue Power indicator should light up.

Important Notes and Indicators

Details on hazardous voltage indicator and signal protection module usage.

Product Specifications

AC Circuit Specifications

Details on outlets, line voltage, current capacity, suppression rating, protection modes, and energy dissipation.

Automatic Voltage Monitoring (AVM) Circuit

Specifications for over-voltage and under-voltage shutoff thresholds.

Power Outlet Faceplate Details

Information on AC connectors, noise filtration, and signal line protection.

Contacting PF Power