Pfaff 3834-3/11 - Sewing Machine Programming: Programs 1 and 2; Programming Procedure for Program 2

26 PFAFF
and
FEED ROLL. PR. 2.6 2.5
SEGMENT K2 _._ 2.5
FEED ROLL. PR. _._ 2.5
and
FEED ROLL. PR. 2.8 2.5
1 K1 0 2.6 2.5
The machine is back to sewing mode.
By operating the knee switchit is possible to
alternate between the two sewing segments.
K1 = knee switch segment 1
K2 = knee switch segment 2
Programming procedure program 2
Sewing of three seam segments with three different
roller presser feed motions.
Programming sequence same as in program 1.
Programming procedure program 1
Sewing two sewing segments with two different
roller presser feed motions.
Incrementing the sewing segments via knee
switch.
Example:
Stitch length 2.5 mm
Roller presser feed motion 1st sewing segment -
2.6 mm
Roller presser feed motion 2nd sewing segment -
2.8 mm
PROGRAM NO. _ _ _._ _._
PROGRAM NO. 1 _._ _._
1 K1 0 _._ _._
INPUT _._ _._
PROGRAM NO. 1 _._ _._
STITCH LENGTH _._ _._
and
STITCH LENGTH _._ 2.5
SEGMENT K1 _._ 2.5
FEED ROLL. PR. _._ 2.5