34 PFAFF
With manual sewing (program number 0)
Pedal in resting position (position 0)
PROGRAM NO. _ _ _._ _._
Select desired program number with numeric keys,
say 12.
and
PROGRAM NO. 12 _._ _._
The status line of the selected program appears,
say:
12 R1 0 _._ _._
The machine is operational.
Sleeve selection
Note:
Sleeve selection is possible only
- in program numbers 3 to 24
- when control is at seam program start and the
sewing procedure has not been started yet.
By pressing key the control switches from the
right hand to the left hand sleeve and vice versa.
Example:
Display, say:
4 R1 0 50 _._ _._
4 L1 0 50 _._ _._
Select program number
With programmed sewing (program number 1 to
24)
This is possible only if the control is at the sewing
program start and the sewing procedure has not
been started yet.
Display, say:
10 R1 0 50 2.6 2.5
PROGRAM NO. _ _ _._ _._
Select desired program number with the numeric
keys, say 2.
PROGRAM NO. 2 _._ _._
The status line of the selected program appears,
say:
2 R1 0 50 2.7 2.5
The machine is operational.
Note:
If a sewing program has been interrupted (e.g. after
thread breakage) and key has been pressed
so that the LED is on, a new program number can
only be selected after key is actuated again
and the LED is off.
To Next Page
Loading...
