User Manual
PFX800H Stage Mist 800
Dear Customer,
Thank you for purchasing the Perform FX PFX800H Stage Mist 800. With decades of experience in design and
production, Perform FX is one of the leading manufacturers of professional effects machines and lighting
equipment.
This unit has been designed and manufactured to the highest of standards so you can be assured you have
made a good investment.
For your safety and to ensure you make full use of all the Stage Mist 800 features, please make sure you read
this manual in full.
Safety Advice:
1. Read this manual in full before operating this product.
2. Keep this manual in a safe place for future reference.
3. Heed all warnings and instructions, both in this manual and on the product.
4. Carry and transport this product with care. Dropping this product may result in serious mechanical failure.
5. The manufacturer accepts no responsibility for injury or damage caused as a result of not following the
manual provided.
6. Turn off and unplug this machine from mains supply when not in use.
7. This machine is not waterproof and should not be used outside.
8. In the event of any liquid entering the housing, unplug immediately & contact a qualified engineer.
Protection from Electric Shock:
1. Only connect this unit to a mains socket with suitable trip and RCD protection.
2. To disconnect from the mains socket, always remove by the mains plug. Do not attempt to remove by
pulling the mains cable.
3. Disconnect the unit from the mains supply before cleaning. Cleaning should be carried out with a soft, dry cloth.
4. Do not expose this unit to any liquids.
5. Do not operate near exposed water or in high humidity.
6. Choose a suitable route for mains cables, ensuring trip hazards are avoided and the mains cable is not at
risk of being crushed.
7. Do not open this unit to service. There are no user serviceable parts inside. Any servicing or repairs should
be carried out by a qualified engineer only. Any attempt to service or adapt this unit will leave your warranty
void and could result in serious malfunction or injury.
Protection from Fire:
1. Do not place near sources of heat or ignition.
2. Do not cover or block any ventilation holes.
3. Check your AC wall socket will take the power you are applying to avoid overloading the mains supply.
Protection from Injury and Damage:
1. Do not attempt to modify this unit.
2. Always install the unit in a suitable location where vibrations to the unit are avoided.
3. Check this unit matches the mains voltage and frequency before plugging it in to your mains socket.
4. In the event that any object or liquid enters the machine, switch off immediately, remove from mains and
consult a qualified engineer.
5. Should you experience any malfunction or damage to the mains cable, disconnect from the mains supply
immediately and consult a qualified engineer.
6. All parts should be replaced with genuine spare parts and carried out by a qualified engineer.
To Next Page
Loading...