Need help?Do you have a question about the Pharos Omega PS200 and is the answer not in the manual?
General| Display Type | TFT LCD |
|---|---|
| Touchscreen | Yes |
| Touchscreen Type | Resistive |
| GPS | Yes |
| Expansion | SD card slot |
| Bluetooth | Yes |
Physically install the device, connecting it to the network and printer/MFD.
Update the PS200 with the latest firmware from the Pharos website via USB or Web Admin.
Set up the PS200 with Pharos system details after firmware installation.
Prepare Uniprint or Blueprint Enterprise for successful PS200 integration.
Ensure an EDI Server is operational before proceeding with PS200 installation.
Confirm Blueprint Analyst is installed and registered with all Blueprint Collectors.
Step-by-step procedure for attaching the desk stand to the PS200 Touchscreen unit.
Connect the four main plugs to the PS200 Touchscreen as depicted in the diagram.
Connect the wire loom's other end to network cables, power adapter, and Copy Link.
Plug the power supply into an AC outlet and press the power button to turn on the PS200.
Access the main menu for managing and configuring the PS200 device.
Use the web interface for remote management and configuration of the PS200.
Steps to access and use the PS200 Terminal's Touchscreen Administrator.
Procedure for accessing and navigating the Omega Web Administrator interface.
Instructions for installing PS200 firmware using a USB memory stick.
Ensure the PS200 is running the most recent available firmware release.
Steps to perform a firmware upgrade using the Omega Web Administrator.
Set up host name, IP address, and PEDI settings for server connectivity.
Set the PS200 hostname to match the terminal name in your Pharos server.
Use the Test Connectivity button to validate PEDI settings and establish a session.
Choose attributes like paper size and color for Omega to detect from the copier.
Set the PS200 IP address using DHCP or a static IP configuration.
Set up the Pharos External Device Interface (PEDI) URL, timeout, and password.
Run tests to allow Omega to identify copier properties and send them to the Pharos Database.
Ensure PS200 is wired to the copier's FDI and enabled, then proceed with testing.
Configure PEDI URL, timeout, and password for Pharos External Device Interface.
Access the Omega Web Administrator interface via a web browser for remote management.
To Next Page