Philco PHK26TE - Troubleshooting

17
Caution! Caution! Only after the door seals are
completely dry that should the refrigerator
be powered on.
Replacing the LED light:Replacing the LED light:
Warning: If the LED light cannot be
replaced by the user when the LED light
is damaged, contact our Service Centre
for assistance.
To replace the LED light, the below steps
can be followed:
1. Unplug your refrigerator.
2. Remove light cover by pushing up and
out.
3. Hold the LED cover with one hand and
pull it with the other hand while pressing
the connector latch.
4. Replace LED light and reverse back
the previous steps.
If you experience a problem with your refrigerator or are concerned that the refrigerator
is not functioning correctly, you can carry out some easy checking steps before calling for
service, please see the below table on pages 18. You can carry out some easy checks
according to this section before calling for service.
Warning!Warning! Don't try to repair the refrigerator yourself. If the problem persists after you
have made the checking steps as mentioned below, contact a qualified electrician,
authorized service centre for service if necessary.
Troubleshooting